Hydraulic Cylinder Leaks: Which Ones Fail a Machine and Which Don't

Walk any used equipment yard and you will find wet hydraulics. The question is never "is there oil" — on a working machine there is always oil somewhere — the question is whether what you are looking at is cosmetic, maintenance due, or a rebuilt-cylinder bill hiding under dust. This guide is the sorting system.

Film, weep, drip: the three grades

A film is a thin, even sheen on the rod or around the gland that picks up dust but never forms a drop. Rod seals wipe oil by design; a film on a machine that works daily is normal life, not a defect. Verdict: pass, note it, move on.

A weep is oil that accumulates — a wet ring at the gland, a stripe that runs an inch or two down the barrel, a patch under the pin boss that is damp every morning. A weep means a seal is finishing its service life. It is not an emergency, but it is a seal kit and labor within the year. Verdict: pass with a price adjustment, and say why out loud.

A drip is active loss: a drop that forms while you watch, a puddle under a parked machine, oil tracked down the barrel to the hose end. A dripping cylinder fails the check — not because the seal kit is expensive, but because machines that drip have usually been dripping for a long time, running low on oil, and cavitating the pump that feeds them.

Read the rod before the seal

Seals fail for a reason, and the reason is usually the rod. Sight down each exposed rod in raking light. Pitting from rust — common on machines stored outdoors with cylinders extended — chews seals as fast as you replace them. Scoring (longitudinal scratches you can catch a fingernail in) means debris got dragged through the gland. A bent rod shows as uneven shine and will eat seals forever. New seals on a bad rod is a cosmetic repair; the honest fix is rod rechroming or replacement, and that changes the math entirely.

The drift test: the part sellers skip

External leaks are what you can see. Internal bypass — oil slipping past the piston seal inside the cylinder — is invisible and more expensive. The field test costs nothing: load the system and wait. Curl a full bucket and hold it off the ground; raise the boom to half height and shut the machine off; set a backhoe on its stabilizers and watch them. Measurable sag inside a minute or two is bypass. A loader bucket that slowly uncurls, stabilizers that creep up, a boom that settles — each is an internal reseal job on a cylinder that may look bone dry outside.

Hoses, fittings, and the valve block alibi

Before you condemn a cylinder, confirm the oil is actually coming from it. Oil runs downhill and along hoses, and a leaking fitting above a cylinder dresses the cylinder in oil it did not lose. Wipe everything dry, cycle the function ten times, and look again. A ten-dollar O-ring at a fitting and an eight-hundred-dollar reseal present identically under a week of dust.

Calling the verdict

  • Pass: films only, rods clean and straight, no measurable drift under load.
  • Price it down: a weep or two on clean rods, or one cylinder with slow drift — get a reseal quoted and subtract it.
  • Fail: active drips, pitted or scored rods, fast drift on a primary function, or fresh paint on cylinder barrels on an otherwise unpainted machine — paint on a gland is a confession.

Hydraulics are the machine's bloodstream, and the leak verdict is a ten-minute physical. Wipe, cycle, look, load, wait. The cylinder that fails you in the yard was going to fail you on a job — the yard is just cheaper.