Tire and Track Wear: Reading What's Left and What It Costs

Rubber is the most honest component on a used machine and the most casually misrepresented. "Good rubber" in a listing can mean anything from 80 percent tread to "holds air most weeks." Since a set of loader tires or CTL tracks runs from a few thousand dollars to five figures, the rubber verdict belongs in every negotiation, with numbers attached.

Wheeled machines: four tires, four stories

Tread depth is the headline number. Measure it — a tread gauge costs less than lunch — and measure all four, because fronts and rears wear differently on loaders and backhoes. Quote remaining tread as a fraction of new for that tire model, not a guess. "R4s at 60 percent" is a sentence a seller can be held to; "decent rubber" is not.

Sidewalls kill more equipment tires than tread does. Look for cracking (weathering from sun and age — common on low-hour machines that sat), cuts that expose cord, bubbles that mean broken internal plies, and repair plugs in sidewall territory where no repair is legitimate. A tire with great tread and a corded sidewall is a dead tire wearing a costume.

Mismatches matter on four-wheel-drive machines. Mixed brands or noticeably different wear front-to-back on a 4WD loader or telehandler loads the drivetrain every minute it runs. One new tire among three worn ones is also a question: what happened to the corner that needed it?

Ballast and wear pattern: center-worn tread means chronic over-inflation; shoulder wear, under-inflation; one-sided feathering on a backhoe front axle points at alignment or a bent spindle — a machine problem, not a tire problem.

Tracked machines: lugs, cords, and roots

Rubber tracks on CTLs and mini excavators get judged on three axes. Lug depth: measure a lug mid-track and compare to new spec — below about a third remaining, traction on slopes and wet clay drops fast and replacement is near. Cord exposure: any visible steel belt, anywhere, is terminal; tracks do not heal. Root cracking: cracks at the base of lugs that connect to each other mean the carcass is finishing, even with lug depth left.

Also look at the inside: the drive-lug faces that the sprocket engages. Rounded, chewed drive lugs skip under load — a track that ratchets on a hill is done regardless of its outside appearance. And check age if the machine sat: rubber hardens and glazes with years, and a shiny, slick-feeling track on a low-hour machine will side-slip on slopes its softer twin would hold.

Pricing the rubber into the deal

Get a real quote — tires mounted, or tracks delivered — for the exact sizes on the machine before you negotiate. Then apply the only fair formula: remaining life as a fraction, times replacement cost, is what the rubber is worth; the rest is a deduction. A machine on 30 percent rubber with a $9,000 replacement set is carrying roughly a $6,000 invisible lien, and your offer should say so in those words.

Calling the verdict

  • Pass: measured tread or lug depth above half, no cord anywhere, no sidewall or root cracking, matched sets, even wear.
  • Price it down: functional rubber under half worn-out — deduct by the formula, with the quote in hand.
  • Fail: exposed cord, sidewall bubbles, chewed drive lugs, or a wear pattern that indicts the axle or alignment underneath the rubber.

Sellers round rubber up; replacement invoices do not round at all. Measure, quote, deduct — the tape measure negotiates better than you do.